We've finished spraying the sides of the hull and the 1st Mate is busy putting blue tape all over the deck in preparation of the new gel coat. Meanwhile, it falls to me to disassemble and remove the hardware we don't want painted or we're just not using anymore. The stern, shown below, had four pairs of brackets used to hold a Monitor wind vane steering system I installed prior to our trip to Mexico in 1997. The vane worked fine, using the water sweeping past the boat for power, and the wind telling it which way to turn the wheel, We would set it and forget for up to 24 hours as we made our way down the California coast. The prevailing NW winds didn't vary much until we entered Southern California at Point Conception. Since then, the winds have been either too light or too shifty for it to be much use to us, so we removed the vane and stored it (installing instead a electronic autopilot on the helm). The brackets have sat, stuck to the stern, dripping rust for thirteen years now and it's time to remove them. That part wasn't hard, the sealant I used held up well and the 16 quarter-inch bolts came out with just a little coaxing, but the rust under the brackets will keep me busy for awhile. I have to remove all the sealant so the epoxy filler I use will stick to it. Just another step along the way.
We're both feeling really good about how this project is shaping up, and we're losing a little weight because of the exercise. We get to the boat at 7am and work until lunchtime, nap for an hour and drive back to the boatyard to finish up the day when the shadows get long.
Today a Mexican yard worker next to me gave me a lesson on using polishing compound. I had been using it like rubbing compound, where you keep your powered buffer loaded up with compound and just swirl away until you get a shine... Nope, wrong.
The idea is to spread a thin coat of polishing compound over the area, let it dry for an hour or two and then come back with a clean buffing pad to shine it up. Here's the result of the stern, after a few days of filling, plugging and sanding... priming, painting and buffing.
And from the side...
and the port side hull using the new buffing technique... thanks, Arturo!
3 comments:
You're using the Royal We, I assume, because I haven't done all that much other than tape down a lot of masking that came loose in the wind. Very discouraging, that, but when you're ready to paint that area I'll tape it down again. We will get it one. Nice shine you're getting now, we are going to be so proud of it.
You both amaze me. Capt'n is as close to the real McGiver as I will ever know. Nice shiny boat!
Beautiful results !
Post a Comment